Siemens FS720 - Page 299

'Operation' task card
EVAC panel [NL]
13
299 |
412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
Assigning the 'Evac master' to the hardware
1. Highlight the 'Evac master' element in the tree view.
2. Open the 'Assign dialog' window.
a The hardware tree is depicted. The 'Channel' element that can be assigned
is highlighted in the 'Evac master unit (FTO2007)' element.
Alternatively: If the EVAC panel is installed away from the station, the
corresponding 'UFP' channel must be assigned in the 'RS485 module
(FCA2002)' element, where the EVAC panel is connected to the station.
3. Click on 'Assign'.
a 'Evac master' is assigned to 'Channel'.