Integrating 'Cerberus PACE' system
13
309 |
Building Technologies
1. Highlight the following element in the 'Hardware' task card: 'FC72x' >
'Communication interfaces'
Information: It must be the 'FC72x' station element to which the 'Cerberus
PACE' system is connected.
Information: This and the next two steps can be omitted if the hardware has
already been imported.
2. Create an 'RS485 module (FCA2002)' element under the 'Communication
interfaces' element.
3. Highlight the 'FC72x' station element to which the 'Cerberus PACE' system is
connected in the 'Operation' task card.
4. Create an 'Cerberus PACE' element under the 'FC72x' element.
5. Use 'Assign' to assign the 'Cerberus PACE' element to the relevant 'UFP'
element of the RS485 module.
To Next Page
Loading...
