Siemens FS720 - Page 321

'Network' task card
Network configuration
14
321 |
412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
Configuring remote access via cRSP
1. Configure one ↑ 'Station' as ↑ 'GAP' or 'Secondary GAP'. Link [➙ 314]
2. In 'GAP' or 'Secondary GAP', create a 'Route' element.
3. In the 'Route' element, enter the values for 'Destination address', 'Netmask' and
'Gateway'. You will get the values from your cRSP contact.
4. In 'Ethernet sub-net' create a 'Route' element.
5. In the 'Route' element, enter the values for 'Destination address' and 'Netmask'.
You will get the values from your cRSP contact.
– Enter the Ethernet address of the GAP as the value of 'Gateway'.
You will find information on entering routes in chapter '
Entering routes for external
access to extended networks via GAP [➙ 317]'.
Establishing connection
1. Log in on the cRSP website.
2. Establish the FS720 connection to your ↑ 'Site' (VPN tunnel).
3. Select the 'Connection to IP address' option in the 'Connect' window.
4. Enter 'localhost' or '127.0.0.1'.
5. Click on 'OK'.