Configuring the forwarding of the extinguishing released state
16
394 | 412
15. Use 'Assign' to assign the 'Fire control' element no. 1 to the 'Causes' element
as the cause. To do this, select the 'All isolations' event category on the left in
the 'Assign' dialog and then select the 'Fire control' element no. 1 on the left in
the control tree.
16. Highlight the following element of the flooding zone in the control tree:
'Extinguishing control group' > 'Extinguishing sector control' > 'Causes'
17. Create an 'Auxiliary function off' element under the 'Causes' element.
To Next Page
Loading...
