Exporting and importing CSVs
6
92 | 412
Creating new elements in the CSV file
1. Enter the 'Area address' in the first column.
2. Depending on the element type, enter the 'Section address', 'Zone address',
and 'Channel address' elements.
3. Enter the element type in the 'Type' column, taking the following into account:
– The element type is an abbreviation of the corresponding element in the
detection tree.
– The element type abbreviation must match your localized ↑ BDV.
– If the element type is missing or does not match your localized BDV, the
new elements cannot be imported.
– The table below shows the detection tree elements and the corresponding
element type abbreviations.
– Only the elements listed in the table can be added to the detection tree as
part of a CSV import.
– If the language of this documentation does not match the BDV language,
you may not be able to use the element type abbreviation listed in the
table. Contact your local or regional company for a translation of the
element type abbreviations.
4. Enter additional data, e.g., 'Customer text'.
Element in the detection tree Element type in the CSV file
'Type' column
↑ Section SE
Automatic zone, Single, standard ZAS
Automatic zone, Multi, standard ZAM
Gas zone, CO gas alarm ZG
Manual zone, Standard ZM
Technical zone, Standard (ack./latching) ZT
Sprinkler zone, Standard ZSP
Flow switch zone, Standard ZFS
Sub-system zone, Standard ZSS
Sub-system zone, ASD system ZSA
Autom. detector, wired EAW
Autom. detector, wireless EAR
Collective EC
Manual call point, wired EMW
Manual call point, wireless EMR
Gas detector EG
To Next Page
Loading...
