Preface
RUGGEDCOM ROS
User Guide
xii CLI Command Syntax
CLI Command Syntax
The syntax of commands used in a Command Line Interface (CLI) is described according to the following
conventions:
Example Description
command
Commands are in bold.
command parameter
Parameters are in plain text.
command parameter1 parameter2
Parameters are listed in the order they must be entered.
command parameter1 parameter2
Parameters in italics must be replaced with a user-defined value.
command [parameter1 | parameter2]
Alternative parameters are separated by a vertical bar (|).
Square brackets indicate a required choice between two or more
parameters.
command {parameter3 | parameter4}
Curly brackets indicate an optional parameter(s).
command parameter1 parameter2 {parameter3 |
parameter4}
All commands and parameters are presented in the order they must
be entered.
Related Documents
Other documents that may be of interest include:
• RUGGEDCOM RSG2200 Installation Guide
• RUGGEDCOM M2200 Installation Guide
• RUGGEDCOM RSG2200 Data Sheet
• RUGGEDCOM M2200 Data Sheet
• RUGGEDCOM Fiber Guide
• RUGGEDCOM Wireless Guide
• White Paper: Rapid Spanning Tree in Industrial Networks
System Requirements
Each workstation used to connect to the ROS interface must meet the following system requirements:
• Must have one of the following Web browsers installed:
▪ Microsoft Internet Explorer 8.0 or higher
▪ Mozilla Firefox
▪ Google Chrome
▪ Iceweasel/IceCat (Linux Only)
• Must have a working Ethernet interface compatible with at least one of the port types on the RUGGEDCOM
device
• The ability to configure an IP address and netmask on the computer’s Ethernet interface
To Next Page
Loading...
