Siemens RUGGEDCOM ROS - Adding an IP Gateway

Chapter 3
Device Management
RUGGEDCOM ROS
User Guide
82 Adding an IP Gateway
Figure 41: IP Gateways Table
If IP gateways have not been configured, add IP gateways as needed. For more information, refer to
Section 3.8.2, “Adding an IP Gateway”.
Section 3.8.2
Adding an IP Gateway
To add an IP gateway, do the following:
1. Navigate to Administration » Configure IP Gateways. The IP Gateways table appears.
1
Figure 42: IP Gateways Table
1. InsertRecord
2. Click InsertRecord. The IP Gateways form appears.