Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Deleting a Static Multicast Group 215
4. Click Apply.
Section 5.9.7.3
Deleting a Static Multicast Group
To delete a static multicast group, do the following:
1. Navigate to Multicast Filtering » Configure Static Multicast Groups. The Static Multicast Groups table
appears.
Figure 162: Static Multicast Groups Table
2. Select the group from the table. The Static Multicast Groups form appears.
7
5
6
3
2
1
4
Figure 163: Static Multicast Groups Form
1. MAC Address Box 2. VID Box 3. Priority Box 4. Ports Box 5. Apply Button 6. Delete Button 7. Reload Button
3. Click Delete.
Section 5.10
Managing Port Security
Port security, or port access control, provides the ability to filter or accept traffic from specific MAC addresses.
Port security works by inspecting the source MAC addresses of received frames and validating them against
the list of MAC addresses authorized by the port. Unauthorized frames are filtered and, optionally, the part

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English