Siemens RUGGEDCOM ROS - Adding a Static Multicast Group; Managing Static Multicast Groups; Viewing a List of Static Multicast Groups

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Managing Static Multicast Groups 213
Section 5.9.7
Managing Static Multicast Groups
The following sections describe how to configure and manage a list of known static multicast groups on other
devices:
• Section 5.9.7.1, “Viewing a List of Static Multicast Groups”
• Section 5.9.7.2, “Adding a Static Multicast Group”
• Section 5.9.7.3, “Deleting a Static Multicast Group”
Section 5.9.7.1
Viewing a List of Static Multicast Groups
To view a list of static multicast groups, navigate to Multicast Filtering » Configure Static Multicast Groups.
The Static Multicast Groups table appears.
Figure 159: Static Multicast Groups Table
If a static multicast group is not listed, add the group. For more information, refer to Section 5.9.7.2, “Adding a
Static Multicast Group”.
Section 5.9.7.2
Adding a Static Multicast Group
To add a static multicast group from another device, do the following:
1. Navigate to Multicast Filtering » Configure Static Multicast Groups. The Static Multicast Groups table
appears.