RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Deleting an IP Gateway 83
Figure 43: IP Gateways
1. Destination Box 2. Subnet Box 3. Gateway Box 4. Apply Button 5. Delete Button 6. Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
Destination Synopsis: ###.###.###.### where ### ranges from 0 to 255
Specifies the IP address of destination network or host. For default gateway, both the
destination and subnet are 0.
Subnet Synopsis: ###.###.###.### where ### ranges from 0 to 255
Specifies the destination IP subnet mask. For default gateway, both the destination and
subnet are 0.
Gateway Synopsis: ###.###.###.### where ### ranges from 0 to 255
Specifies the gateway to be used to reach the destination.
4. Click Apply.
Section 3.8.3
Deleting an IP Gateway
To delete an IP gateway configured on the device, do the following:
1. Navigate to Administration » Configure IP Gateways. The IP Gateways table appears.
Figure 44: IP Gateways Table
2. Select the IP gateway from the table. The IP Gateways form appears.
To Next Page
Loading...
Need help?
General
