Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Managing SNMP Users 183
Before configuring SNMPv3, note the following:
• Each user belongs to a group
• A group defines the access policy for a set of users
• An access policy defines what SNMP objects can be accessed for (i.e. reading, writing and creating
notifications)
• A group determines the list of notifications its users can receive
• A group also defines the security model and security level for its users
For SNMPv1 and SNMPv2c, a community string can be configured. The string is mapped to the group and
access level with a security name, which is configured as User Name.
The following sections describe how to setup and manage SNMP on the device:
• Section 5.7.1, “Managing SNMP Users”
• Section 5.7.2, “Managing Security-to-Group Mapping”
• Section 5.7.3, “Managing SNMP Groups”
Section 5.7.1
Managing SNMP Users
The following sections describe how to configure and manage SNMP users, refer to the following:
• Section 5.7.1.1, “Viewing a List of SNMP Users”
• Section 5.7.1.2, “Adding an SNMP User”
• Section 5.7.1.3, “Deleting an SNMP User”
Section 5.7.1.1
Viewing a List of SNMP Users
To view a list of SNMP users configured on the device, navigate to Administration » Configure SNMP »
Configure SNMP Users. The SNMP Users table appears.
Figure 128: SNMP Users Table
If users have not been configured, add users as needed. For more information, refer to Section 5.7.1.2, “Adding
an SNMP User”.

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English