Chapter 3
Device Management
RUGGEDCOM ROS
User Guide
80 Deleting an IP Interface
Parameter Description
Subnet Synopsis: ###.###.###.### where ### ranges from 0 to 255
Default: 255.255.255.0
Specifies the IP subnet mask of this device. An IP subnet mask is a 32-bit number that
is notated by using four numbers from 0 through 255, separated by periods. Typically,
subnet mask numbers use either 0 or 255 as values (e.g. 255.255.255.0) but other
numbers can appear.
IMPORTANT!
Each IP interface must have a unique network address.
4. Click Apply.
Section 3.7.3
Deleting an IP Interface
To delete an IP interface configured on the device, do the following:
1. Navigate to Administration » Configure IP Interfaces. The IP Interfaces table appears.
Figure 39: IP Interfaces Table
2. Select the IP interface from the table. The IP Interfaces form appears.
To Next Page
Loading...
