Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Chapter 1
Introduction
SNMP Management Interface Base (MIB) Support 9
Services Port Number Port Open Port Default
Access
Authorized
Note
DHCP, DHCP Agent UDP/67 sending
msg if enabled - if
received, always
come to CPU,
dropped if service
not configured
Open Open No
RCDP — Open
(configurable)
Closed Yes
Section 1.5
SNMP Management Interface Base (MIB) Support
ROS supports a variety of standard MIBs, proprietary RUGGEDCOM MIBs and Agent Capabilities MIBs, all for
SNMP (Simple Network Management Protocol).
• Section 1.5.1, “Supported Standard MIBs”
• Section 1.5.2, “Supported Proprietary RUGGEDCOM MIBs”
• Section 1.5.3, “Supported Agent Capabilities”
Section 1.5.1
Supported Standard MIBs
ROS supports the following standard MIBs:
Standard MIB Name Title
RFC 2578 SNMPv2-SMI Structure of Management Information Version 2
RFC 2579 SNMPv2-TC Textual Convention s for SMIv2
SNMPv2-CONF Conformance Statements for SMIv2RFC 2580
IANAifType Enumerated Values of the ifType Object Defined ifTable defined in
IF-MIB
RFC 1907 SNMPv2-MIB Management Information Base for SNMPv2
RFC 2011 IP-MIB SNMPv2 Mnagement Information Base for Internet Protocol using
SMIv2
RFC 2012 TCP-MIB SNMPv2 Management Information Base for the Transmission
Control Protocol using SMIv2
RFC 2013 UDP-MIB Management Information Base for the UDP using SMIv2
RFC 1659 RS-232-MIB Definitions of Managed Objects for RS-232-like Hardware Devices
RFC 2863 IF-MIB The Interface Group MIB
RFC 2819 RMON-MIB Remote Network Monitoring (RMON) management Information base
RFC 4188 BRIDGE-MIB Definitions of Managed Objects for Bridges

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English