Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Deleting an SNMP Group 193
Section 5.7.3.3
Deleting an SNMP Group
To delete an SNMP group, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Access. The SNMP Access table
appears.
Figure 141: SNMP Access Table
2. Select the group from the table. The SNMP Access form appears.
9
7
8
6
5
4
3
2
1
Figure 142: SNMP Access Form
1. Group Box 2. Security Model Box 3. Security Level Box 4. ReadViewName Box 5. WriteViewName Box
6. NotifyViewName Box 7. Apply Button 8. Delete Button 9. Reload Button
3. Click Delete.
Section 5.8
Managing Network Discovery
ROS supports the Link Layer Discovery Protocol (LLDP) and RUGGEDCOM Discovery Protocol (RCDP), both
Layer 2 protocols for automated network discovery.
The following sections describe how to configure and manage network discovery, refer to the following:
• Section 5.8.1, “Network Discovery Concepts”

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English