Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
192 Adding an SNMP Group
Figure 140: SNMP Access Form
1. Group Box 2. Security Model Box 3. Security Level Box 4. ReadViewName Box 5. WriteViewName Box
6. NotifyViewName Box 7. Apply Button 8. Delete Button 9. Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
Group Synopsis: Any 32 characters
The group name to which the security model and name belong. This name is used as an
index to the SNMPv3 VACM Access Table.
SecurityModel Synopsis: { snmpV1, snmpV2c, snmpV3 }
Default: snmpV3
In order to gain the access rights allowed by this entry, configured security model must
be in use.
SecurityLevel Synopsis: { noAuthNoPriv, authNoPriv, authPriv }
Default: noAuthNoPriv
The minimum level of security reqwuired in order to gain the access rights allowed by
this entry. A security level of noAuthNoPriv is less than authNoPriv, which is less than
authPriv.
ReadViewName Synopsis: { noView, V1Mib, allOfMib }
Default: noView
This parameter identifies the MIB tree(s) to which this entry authorizes read access. If
the value is noView, then no read access is granted.
WriteViewName Synopsis: { noView, V1Mib, allOfMib }
Default: noView
This parameter identifies the MIB tree(s) to which this entry authorizes write access. If
the value is noView, then no write access is granted.
NotifyViewName Synopsis: { noView, V1Mib, allOfMib }
Default: noView
This parameter identifies the MIB tree(s) to which this entry authorizes access for
notifications. If the value is noView, then no access for notifications is granted.
4. Click Apply.
To Next Page
Loading...
Need help?
General
