Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
188 Viewing a List of Security-to-Group Maps
• Section 5.7.2.3, “Deleting a Security-to-Group Map”
Section 5.7.2.1
Viewing a List of Security-to-Group Maps
To view a list of security-to-group maps configured on the device, navigate to Administration » Configure
SNMP » Configure SNMP Security to Group Maps. The SNMP Security to Group Maps table appears.
Figure 133: SNMP Security to Group Maps Table
If security-to-group maps have not been configured, add maps as needed. For more information, refer to
Section 5.7.2.2, “Adding a Security-to-Group Map”.
Section 5.7.2.2
Adding a Security-to-Group Map
Multiple combinations of security models and groups can be mapped (up to a maximum of 32) for SNMP.
To add a security-to-group map, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Security to Group Maps. The SNMP
Security to Group Maps table appears.
Figure 134: SNMP Security to Group Maps Table
1. InsertRecord
2. Click InsertRecord. The SNMP Security to Group Maps form appears.
To Next Page
Loading...
