Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Chapter 3
Device Management
Managing IP Gateways 81
7
8
1
2
3
4
5
6
9
Figure 40: IP Interfaces Form
1. IP Address Type Box 2. IP Address Box 3. Subnet Box 4. Apply Button 5. Delete Button 6. Reload Button
3. Click Delete.
Section 3.8
Managing IP Gateways
ROS allows up to ten IP gateways to be configured. When both the Destination and Subnet parameters are
blank, the gateway is considered to be a default gateway.
NOTE
The default gateway configuration will not be changed when resetting all configuration parameters to
their factory defaults.
The following sections describe how to set up and manage IP gateways:
• Section 3.8.1, “Viewing a List of IP Gateways”
• Section 3.8.2, “Adding an IP Gateway”
• Section 3.8.3, “Deleting an IP Gateway”
Section 3.8.1
Viewing a List of IP Gateways
To view a list of IP gateways configured on the device, navigate to Administration » Configure IP Gateways.
The IP Gateways table appears.

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English