Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Viewing a List of SNMP Groups 191
Section 5.7.3.1
Viewing a List of SNMP Groups
To view a list of SNMP groups configured on the device, navigate to Administration » Configure SNMP »
Configure SNMP Access. The SNMP Access table appears.
Figure 138: SNMP Access Table
If SNMP groups have not been configured, add groups as needed. For more information, refer to Section 5.7.3.2,
“Adding an SNMP Group”.
Section 5.7.3.2
Adding an SNMP Group
To add an SNMP group, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Access. The SNMP Access table
appears.
1
Figure 139: SNMP Access Table
1. InsertRecord
2. Click InsertRecord. The SNMP Access form appears.

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English