Siemens RUGGEDCOM ROS - Deleting a Static MAC Address

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
178 Deleting a Static MAC Address
Parameter Description
Port Synopsis: 1 to maximum port number or { Learn }
Default: Learn
Enter the port number upon which the device with this address is located. The security
mode of the port being selected should not be '802.1X'.
If the port should be auto-learned, set this parameter to 'Learn'. The option 'Learn' is
applicable for Port Security in 'Static MAC' mode.
CoS Synopsis: { N/A, Normal, Medium, High, Crit }
Default: N/A
Prioritizes traffic for the specified MAC address. To not prioritize traffic based on the
address, select N/A.
4. Click Apply.
Section 5.5.4.3
Deleting a Static MAC Address
To delete a static MAC address from the Static MAC Address Table, do the following:
1. Navigate to MAC Address Tables » Configure Static MAC Addresses. The Static MAC Addresses table
appears.
Figure 122: Static MAC Addresses Table
2. Select the MAC address from the table. The Static MAC Addresses form appears.