Siemens RUGGEDCOM ROS User Manual

Chapter 3
Device Management
RUGGEDCOM ROS
User Guide
78 Adding an IP Interface
Figure 36: IP Interfaces Table
If IP interfaces have not been configured, add IP interfaces as needed. For more information, refer to
Section 3.7.2, “Adding an IP Interface”.
Section 3.7.2
Adding an IP Interface
To add an IP interface, do the following:
1. Navigate to Administration » Configure IP Interfaces. The IP Interfaces table appears.
1
Figure 37: IP Interfaces Table
1. InsertRecord
2. Click InsertRecord. The Switch IP Interfaces form appears.

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English