RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Deleting a Security-to-Group Map 189
Figure 135: SNMP Security to Group Maps Form
1. Security Model Box 2. Name Box 3. Group Box 4. Apply Button 5. Delete Button 6. Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
SecurityModel Synopsis: { snmpV1, snmpV2c, snmpV3 }
Default: snmpV3
The Security Model that provides the name referenced in this table.
Name Synopsis: Any 32 characters
The user name which is mapped by this entry to the specified group name.
Group Synopsis: Any 32 characters
The group name to which the security model and name belong. This name is used as an
index to the SNMPv3 VACM Access Table.
4. Click Apply.
Section 5.7.2.3
Deleting a Security-to-Group Map
To delete a security-to-group map, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Security to Group Maps. The SNMP
Security to Group Maps table appears.
To Next Page
Loading...
Need help?
General
