Siemens RUGGEDCOM ROS User Manual

RUGGEDCOM ROS
User Guide
Chapter 4
System Administration
Configuring the RADIUS Client 117
NOTE
The RADIUS client uses the Password Authentication Protocol (PAP) to verify access.
To configure access to either the primary or backup RADIUS servers, do the following:
1. Navigate to Administration » Configure Security Server » Configure RADIUS Server. The RADIUS
Server table appears.
Figure 72: RADIUS Server Table
2. Select either Primary or Backup from the table. The RADIUS Server form appears.
7
6
5
4
3
2
1
Figure 73: RADIUS Server Form
1. Server Box 2. IP Address Box 3. Auth UDP Port Box 4. Auth Key Box 5. Confirm Auth Key Box 6. Apply Button
7. Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
Server Synopsis: Any 8 characters
Default: Primary
This field tells whether this configuration is for a Primary or a Backup Server.
IP Address Synopsis: ###.###.###.### where ### ranges from 0 to 255
The Server IP Address.
Auth UDP Port Synopsis: 1 to 65535
Default: 1812
The IP Port on server.
Auth Key Synopsis: 31 character ASCII string
The authentication key to be shared with server.

Siemens RUGGEDCOM ROS Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROS
Category	Control Unit
Language	English