DC link components
5.2 Chassis
AC Drive
200 Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
④
Remove the three screws on the blanking cover.
Remove the blanking cover.
⑤
Install the Braking Module instead of the blanking cover
and secure it with the blanking cover screws that were
⑥
Secure the adapter bars at the DCNA connection using a
nut, so that the bar cannot be twisted. For this purpose, a
small bolt is attached to the adapter bar, which must be
located on the lower side of the DCNA connection.
Secure the connecting cable to the DC link with two
screws (Braking Module connection) and with two nuts
Attach the
- cover plate, top - step
③
- cover plate, left - step
②
- the front cover - step
①
An opening above the connections for the braking resistor (R1, R2) is provided in the cover
for connecting the cable to the braking resistor.
Note
You must carefully observe the specified tightening torques.
To Next Page
Loading...
