Supplementary system components and encoder system integration
8.1 Sensor Modules
AC Drive
360 Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
Sensor Module Cabinet-Mounted SMC30
8.1.4.1
The Sensor Module Cabinet-Mounted SMC30 evaluates encoder signals and transmits the
speed, actual position value and, if necessary, the motor temperature and reference point via
DRIVE-CLiQ to the Control Unit.
The SMC30 is used to evaluate encoder signals from encoders with TTL, HTL, or SSI
interfaces.
A combination of TTL/HTL signal and SSI absolute signal is possible at terminals
X521/X531, if both signals are derived from the same measured variable.
Interface description
Overview
Figure 8-9 Interface description of the SMC30
To Next Page
Loading...
