Siemens S120 - DRIVE-Cliq Coupling; Description; Interface Description; Overview

Accessories
9.2 DRIVE-CLiQ coupling
AC Drive
398 Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
9.2
DRIVE-CLiQ coupling
9.2.1
Description
The DRIVE-CLiQ coupling is used to connect 2 DRIVE-CLiQ cables in accordance with
degree of protection IP67 acc. to EN 60529.
In addition to the data lines, the power supply contacts of DRIVE-CLiQ are also routed via
the coupling.
You can find information on the permissible cable length in Chapter DRIVE-CLiQ signal
cables (Page 427)
NOTICE
Damage through use of incorrect DRIVE-CLiQ cables
Damage or malfunctions can occur on the devices or system when DRIVE-CLiQ cables are
used that are either incorrect or have not been approved for this purpose.
• Only use suitable DRIVE-CLiQ cables that have been approved by Siemens for the
particular application.
9.2.2
Interface description
9.2.2.1
Overview
①
Rating plate
②
Protective cap, Yamaichi, order number: Y-ConAS-24-S
Figure 9-10 Interface overview, DRIVE-CLiQ coupling