Siemens S120 - Installing a Braking Module in a Power Module, Frame Size FX

DC link components
5.2 Chassis
AC Drive
Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
199
5.2.1.9
Installing a Braking Module in a Power Module, frame size FX
①
Loosen the two M6 screws.
Remove the front cover to the top.
②
Loosen the two screws from the cover plate at the top
and the M6 nut on the left-hand side.
Remove the cover plate at the left.
③
Loosen the four screws from the cover plate at the top
and the three securing screws at the rear.
Remove the cover plate at the top.