Siemens S120 - Page 202

DC link components
5.2 Chassis
AC Drive
202 Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
④
Remove the three screws on the blanking cover.
Remove the blanking cover.
⑤
Install the Braking Module instead of the blanking cover and
secure it with the blanking cover screws that were
previously removed.
⑥
Secure the connecting cable to the DC link with two screws
(Braking Module connection) and with two nuts (DC-link
connection).
Attach the
- cover plate, top – step
③
- cover plate, left – step
②
- the front cover – step
①
An opening above the connections for the braking resistor (R1, R2) is provided in the cover
for connecting the cable to the braking resistor.
Note
You must carefully observe the specified tightening torques.