Accessories
9.1 DRIVE-CLiQ cabinet bushing
AC Drive
Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
395
1. Insert the DRIVE CLiQ cabinet bushing from the outside of the control cabinet through the
cutout in the control cabinet.
2. Attach the DRIVE-CLiQ cabinet bushing to the outer control cabinet panel using 2 M3
screws and 2 nuts. In order to ensure good electromagnetic compatibility, a good
electrical connection must be established between the DRIVE-CLiQ cabinet gland and
the cabinet panel over a large surface area.
M3 screw, tightening torque 0.8 Nm
DRIVE-CLiQ cabinet bushing
Figure 9-6 Installing the DRIVE-CLiQ cabinet bushing for cables with DRIVE-CLiQ connectors
To Next Page
Loading...
