Line Modules Booksize
3.1 Introduction
Booksize power units
Manual, (GH2), 06/2008, 6SL3097-2AC00-0BP6
149
General characteristics of the Line Modules
● Connection voltage 380 V 3 AC -10% (-15% <1 min) to 480 V 3 AC +10% (47 to 63 Hz)
● Suitable for TN, TT, and IT supply systems
● Internal/external air cooling
● Short-circuit/ground-fault-proof during the precharge phase
● Integrated DC link and electronics current busbar connection
● LEDs for indicating statuses and for diagnostics
Characteristics of the Active Line Modules
● Regulated DC link voltage
● Regenerative feedback capability
● Sinusoidal line currents
● Electronic type plate
● DRIVE-CLiQ interface for communicating with the Control Unit and/or other components
in the drive line-up
– Integration in system diagnostics
● For Active Line Modules as of 55 kW: outgoing circuit for DC link busbar possible on
both sides
● For all Active Line Modules with order numbers ending in 3 (6SL xxxxxxx 3): outgoing
circuit for DC link busbar possible on both sides
Characteristics of the Smart Line Modules
● Unregulated DC link voltage
● Regenerative feedback capability
● Block-type network currents in feedback direction
● For all Smart Line Modules as of 16 kW with order numbers ending in 3 (6SL xxxxxxx
3): outgoing circuit for DC link busbar possible on both sides
Characteristics of the Basic Line Modules
● Unregulated DC link voltage
● No regenerative feedback capability
● For all Basic Line Modules: outgoing circuit for DC link busbar possible on both sides
To Next Page
Loading...
