Siemens SINAMICS S120 - Page 33

System Overview
1.8 Standards
Booksize power units
Manual, (GH2), 06/2008, 6SL3097-2AC00-0BP6
33
Standards Title
IEC 60287-1 to -3 Cables - Calculation of the current carrying capacity
Part 1: Current carrying capacity equations (100 % load factor) and calculating the losses
Part 2: Thermal resistance
Part 3: Main sections for operating conditions
EN 60529 Degrees of protection provided by enclosures (IP code)
EN 60664-X Insulation coordination for equipment within low-voltage systems
Part 1: Principles, requirements and tests
Part 3: Use of coating, potting or moulding for protection against pollution
EN 60721-3-X Classification of environmental conditions
Part 3-0: Classification of environmental parameters and their severities; Introduction
Part 3-1: Classification of environmental parameters and their severities; Long-term storage
Part 3-2: Classification of environmental parameters and their severities; Transport
Part 3-3: Classification of environmental parameters and their severities; Stationary use, weather
protected
EN 61000-6-X Electromagnetic compatibility (EMC)
Part 6-1: Generic standard; Immunity for residential, commercial and light-industrial environments
Part 6-2: Generic standards; Immunity for industrial environments
Part 6-3: Generic standards; Generic standard emission for residential, commercial and light-
industrial environments
Part 6-4: Generic standards; Generic standard noise emission for industrial environments
EN 61140 Protection against electric shock; Common aspects for installation and equipment
EN 61158 Digital data communications for measurement and control - Fieldbus for use in industrial control
systems
EN 61800-2 Adjustable-speed electrical power drive systems;
Part 2: General requirements - Rating specifications for low-voltage adjustable frequency a.c.
power drive systems
EN 61800-3 Adjustable-speed electrical power drive systems;
Part 3: EMC - Requirements and specific test methods
EN 61800-5-X Adjustable-speed electrical power drive systems;
Part 5: Safety requirements;
Main section 1: Electrical, thermal and energy requirements
Main section 2: Functional safety requirements
VDE 0100 Teil X
(IEC 60364-X-X)
Erection of power installations with nominal voltages up to 1000 V;
Part 200: Definitions
Part 410: Protection for safety, protection against electric shock
Part 420: Protection for safety, protection against thermal effects
Part 430: Protection of cables and conductors for over-current
Part 470: Protection for safety; use of protection for safety
Part 450: Protection for safety, protection against undervoltage
Part 5xx: Selecting and erecting electrical equipment
Part 520: Wiring systems
Part 540: Earthing, protective conductor, potential bonding conductor
Part 560: Electrical equipment for safety purposes
DIN EN ISO 9001 Quality management systems - requirements
UL 50 Enclosures for Electrical Equipment
UL 508 Industrial Control Equipment
UL 508C Safety for Power Conversion Equipment