Page 6 of 16 7482255 Rev 01 Siemens
October 2002
Installing the G50 DIMAQ-IP
22. As demonstrated in Figure 5-5, attach the connector of the A70-2 PPCL
PCB to the A70 DVSC PCB located in the host module enclosure.
23. Install the four M3 X 6 (CK3 X 6) screw, supplied in the kit, through the A70-
2 PPCL PCB, into the A70 DVSC PCB as indicated in Figure 5-5.
24. Place the PPCL shielding plate on the host module, in its original position
(Figure 5-2).
25. As depicted in Figure 5-6, install the four screws that were removed from
the PPCL shielding plate shown in Figure 5-2.
26. Install connector J2 in the PPCL shielding plate and secure it in place with
the two M2.5 X 6 screws and external lock washers that are supplied in the
kit.
Figure 5-5 Installing the A70-2 PPCL PCB
!
Caution: Use care to avoid dropping loose hardware into the system during the
disassembly and assembly of the G50. Loose hardware can short electronic
components. Safeguard all hardware for reinstallation.
To Next Page
Loading...
