Siemens SONOLINE G50 - Removing the Monitor Post Cover; Removing the Sub Control Panel (LCD)

Siemens 7482255 Rev 01 Page 29 of 52
October 2002
Chapter 4 - Removing and Replacing Spare Parts
5. Remove the monitor post cover by loosening the two screws located under
the handle shown in Figure 4-23.
6. Loosen the two screws from the sub control panel shown in Figure 4-24.
!
Caution: In the following steps, hardware removed from the monitor assembly
can fall into the system. Loosen the hardware then carefully remove it to prevent
it falling. If screws or washers fall into the system, do not continue until they have
been recovered.
Figure 4-23 Removing the Monitor Post Cover (View from Under Rear Handle)
Figure 4-24 Removing the Sub Control Panel (LCD)
Rear Handle