Siemens SONOLINE G50 - Removing the MO Drive Bay; MO Drive and Bay Assembly

Siemens 7482255 Rev 01 Page 39 of 52
October 2002
Chapter 4 - Removing and Replacing Spare Parts
17. Turn the monitor to one side and then the other while you remove the four
screws securing the MO drive bay to the system.
18. Disconnect the fan cables from the MO drive.
19. Extract the MO drive bay with the attached MO drive.
20. Invert the drive and drive bay, and disconnect the signal cable and power
cable from MO drive.
21. Invert the MO drive bay to its original position.
22. Remove the three screws from the MO drive bay to separate it from the MO
drive.
23. Separate the MO drive from its shield case, by removing the one screw
from the shield case that is indicated in Figure 4-35.
Figure 4-34 Removing the MO Drive Bay
Figure 4-35 MO Drive and Bay Assembly