Siemens 7482255 Rev 01 Page 3 of 8
October 2002
Chapter 9 - Planned Maintenance
4.0 Preparations
Perform the following preparations before beginning the maintenance routines.
1. Discuss the system performance with the customer; determine what con-
cerns the customer might have regarding the system performance.
2. In the maintenance report, record the information obtained from the cus-
tomer, and the actions taken to resolve these concerns.
3. Save the system preset data on an MO diskette.
4. Turn off the system and disconnect the power cable from the external
power source.
5.0 Cleaning the System
Use a soft cloth, lightly moistened with a mild soap solution, to clean the
surface of the system, including the system control panel, transducer holders,
system side panels, and any on-board OEM peripheral devices. Refer to the
operating instructions for additional information on cleaning the system,
transducers, and filters.
6.0 Cleaning Subsystems
Clean the following subsystems:
1. On each side of the system, remove the air filter retainer (2 total) as indi-
cated in Figure 9-1.
!
Warning: When handling parts that may have had patient contact, take appropriate precau-
tions against exposure to blood borne pathogens.
!
Caution: Do not use alcohol, other organic solvents, or cleansing agents
that contain alcohol or organic solvents to clean the
G60 S.
Figure 9-1 Air Filter Removal
To Next Page
Loading...
