Siemens 7482255 Rev 01 Page 15 of 42
October 2002
Chapter 8 - Software
4. Press the SET key to display the feature installation screen shown in
Figure 8-7.
5. Verify what prerequisite options are installed on the system; for the Stress
Echo option, verify that the DIMAQ-IP option is present in the Installed
Options list indicated in Figure 8-3.
6. Insert the Stress Echo option key disk in the MO drive; use the original key
disk that used to install the feature key.
7. Use the trackball to select the Uninstall button shown in Figure 8-7.
8. Press the SET key.
9. When the uninstall procedure is completed, verify that the Stress Echo
menu item no longer appears in the menu item list of the Preset screen
(Figure 8-6) nor on the Installed Option list (Figure 8-7).
10. Eject the MO disk from the MO drive.
!
Caution: Uninstalling a prerequisite feature key, before uninstalling a feature
that it supports, can cause the loss of the supported feature key. Uninstall the
Stress Echo feature key before uninstalling the DIMAQ-IP software feature key.
Note: A feature key disk can only be used to enable an option on the system for
which it was provided. A key disk will be required for each option installed on each
individual system.
Figure 8-7 Feature Installation Screen
To Next Page
Loading...
