Page 8 of 16 7482255 Rev 01 Siemens
October 2002
Installing the G50 DIMAQ-IP
30. Install the DIMAQ-IP module in the system and fasten the three screws
indicated in Figure 5-8.
31. Connect the DIMAQ-IP power cable to the DIMAQ-IP module: See connec-
tion in Figure 5-9 and Figure 5-10.
32. Reinstall the power-cable clamp shown in Figure 5-7 that was removed in
step 28. See Figure 5-9.
33. Identify the cables that were detached from the host module in step 3.
Figure 5-8 DIMAQ-IP Installation
Note: When installing the DIMAQ-IP module, verify that no cables are pinched
between parts or surfaces. Push the DIMAQ-IP module in slowly, verifying that no
cables are pinched between the DIMAQ-IP module and the surrounding equip-
ment.
When connecting cables between the DIMAQ-IP module and the host module,
read the connector labels carefully and confirm that the cables are attached to the
proper connector.
!
Caution: Use fasteners of the correct length to prevent damage to underlying
equipment. See "Fastener Reference" (page H-1).
Figure 5-9 Installing Cable Clamps
To Next Page
Loading...
