Page 14 of 52 7482255 Rev 01 Siemens
October 2002
Installing the Color Printer and the VCR
4.0 Installing the Color Printer and the VCR
Use the instructions provided in this section to install the color printer (CP900)
and the VCR (SVO-9500) in the G50 or the G60 S. Replacement of the color
printer or the VCR requires approximately 15 minutes.
4.1 Tools Required
Use a number 2 Phillips screwdriver to perform these procedures.
4.2 Installing the Color Printer
Use the following instructions to install the CP900 color printer in the G50 or the
G60 S.
Note: Several printer and VCR options can be installed in the G50 and the G60
S: a black and white printer, a color printer, and two types of VCR. Install these
options in the OEM bay or on top of the OEM bay, as indicated in Figure 4-12
Figure 4-12 OEM Bay and Top of Bay
!
Warning: The replacement procedure described in this section involves the removal and re-
installation of threaded fasteners. The installation of over-long fasteners is some locations can
penetrate and damage the underlying equipment or short circuits that are energized at 90 Vac
to 264 Vac. The potential damage can affect equipment performance; the potential shorting of
the electrical circuits can produce shock hazards that are capable of causing serious injury or
death. Verify that threaded fasteners of the correct length are installed in the equipment.
When fasteners are removed, store them with the related components for re-installation. Refer
to this procedure to verify that only fasteners of the correct length are re-installed. Re-install
threaded fasteners slowly, and verify that they do not contact underlying equipment.
Top of OEM
Bay
OEM Bay
!
Warning: Use threaded fasteners of the length cited here to avoid damaging or shorting under-
lying equipment.
To Next Page
Loading...
