Siemens 7482255 Rev 01 Page 7 of 16
October 2002
Chapter 5 - Installing Equipment Options
27. At the MO drive, remove the two screws installed from the inside of the sys-
tem that secure the blank panel located below the MO drive, and remove
the panel.
28. At the upper right corner of the host module shown in Figure 5-7, remove
the screw that holds the DIMAQ-IP power-cable clamp in place.
29. Move all cables to the sides of the system to allow access to the DIMAQ-IP
installation site.
Figure 5-6 Reinstalling the PPCL Shielding Plate
Figure 5-7 DIMAQ-IP Power-cable Clamp
!
Caution: The close clearances around the DIMAQ-IP create the potential for
cable damage. Verify that no cable is pinched or abraded when the DIMAQ-IP is
removed.
To Next Page
Loading...
