Siemens 7482255 Rev 01 Page 5 of 52
October 2002
Chapter 4 - Removing and Replacing Spare Parts
8. Use the Allen wrench to remove the two socket head cap screws and
remove the single bolt shown in the upper right corner of Figure 4-6: Hold
the monitor securely while removing these screws.
9. Remove the monitor from the post.
10. Remove the mounting hardware from the original monitor; this hardware
will be installed on the replacement monitor.
Figure 4-5 Attaching the Monitor Cables
Safety Ground
Screws identified as CK4 X 12 in Figure 4-5 are M4 X 12 binding head with external
lock washer.
The safety ground cable is attached with an M4 X 12 screw through the lug, with an
external toothed M4 lock washer located between the lug and the chassis.
To Next Page
Loading...
