Siemens SONOLINE G50 - Viewing Service Records; Recording Service Activities

Page 34 of 42 7482255 Rev 01 Siemens
October 2002
Service Screens and Menus
The display of the Service History screen is configured for service data entry
(Figure 8-24) when it opens; the History List field displays Today and the Date
of Service field displays the present date. The Service Engineer Name remains
blank and each of the service category keys displays an initial default.
6.10.1 Viewing Service Records
Service activities are recorded and recalled according to the date entered in
the Date of Service field. Once entered, the date of service is listed in the drop-
down History List combo box. To view a service record, open the drop-down
History List combo box and select the date of the service; select the View
button located at the bottom of the screen to display the key and memo data
recorded for the service activity performed on that date.
View the fields located below the History List to rapidly determine if the
displayed record is the record that you wish to review. See "Field Descriptions"
(page 8-35) for a description of the Key fields.
6.10.2 Recording Service Activities
Each service record allows the service engineer to enter key data in the fields
labeled Key 1 through Key 5. These key field entries can be used to categorize
the nature of the service activity for rapid review in the future.
Figure 8-24 Service History Screen
Service
Home
Site
System
HW / SW
Diagnostics
Log
Service History
Backup / Restore
Service History
InputView Save
Memo
Today
Select
Select
Select
Select
Select
DD / MM / YYYY
History List
Date of Service
Service Engineer Name
Key 1
Key 2
Key 3
Key 4
Key 5