Siemens SONOLINE G50 - 5.0 Service Software Operation

Siemens 7482255 Rev 01 Page 17 of 42
October 2002
Chapter 8 - Software
5.0 Service Software Operation
The Service Software functions allow the user to verify the operation of the
hardware and to detect failed circuit boards. Use the methods described in this
section to investigate the cause of malfunctions and the circumstances that
existed when the malfunction occurred.
The Service Software screens support only the English language.
5.1 Starting Up the Service Software
The flow chart shown in Figure 8-8 displays the start-up sequence for the
service software. Figure 8-9 shows the Authentication (password) screen.
When this screen is displayed, enter the password and select the OK button.
Access all service software functions from the Main Menu screen shown in
Figure 8-10.
Figure 8-8 Service Software Start-up Sequence
Yes
No
Start
Open Preset Screen
Select Service
Enter Password
Password Correct?
Main Menu Displayed
Message: Password is Wrong
Select Ok Button
Select Ok Button