Page 12 of 52 7482255 Rev 01 Siemens
October 2002
Removing and Installing the Black and White Printer
5. Install, loosely, the two M3 X 8 binding head screws and external lock
washers into bracket F; place the printer in the bay and secure the printer in
place by tightening the two screws.
3.4 Verifying the Operation of the Black and White
Printer
Use the following instructions to verify the operation of the black and white
printer.
1. Verify that the cables are connected correctly: See Figure 4-11.
2. Verify that the number 1 DIP switch is set in the On position; set the remain-
ing switches to Off (downward).
3. Connect the power cable to the system outlet.
4. Connect a transducer to the G50 or the G60 S; this transducer will be used
to produce a printable study.
5. Turn the Main Power switch on.
6. Turn the Standby switch on.
7. Confirm that an image is displayed on the monitor.
8. Turn on the power switch of the P91W.
9. Press F4 to display the Menu screen on the monitor.
10. Select Customize Keys from the menu, using the trackball.
11. Press SET.
Figure 4-11 P91W Cable Connections and Dip Switch
To Next Page
Loading...
