Siemens 7482255 Rev 01 Page 11 of 42
October 2002
Chapter 8 - Software
5. Press the SET key to display the feature installation screen shown in
Figure 8-3.
6. Verify that prerequisite options are installed on the system; for the Stress
Echo option, verify that the DIMAQ-IP option is present in the Installed
Options list indicated in Figure 8-3.
7. Insert the Stress Echo option key disk in the MO drive.
8. Use the trackball to select the Install button shown in Figure 8-3.
9. Press the SET key.
Note: The installation of specific feature keys can require the existence of previ-
ously installed options or specific software revision levels; for example, the Stress
Echo feature requires the presence of the DIMAQ-IP.
Note: A feature key disk can only be used to enable an option on the system for
which it was provided. A key disk will be required for each option installed on each
individual system.
Figure 8-3 Feature Installation Screen
To Next Page
Loading...
