SIPOS SEVEN 2SA7 - Approach End Position CLOSED in Torque Dependent Cut-off Mode; End Position Setting Correct

Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
Page 52 Y070.302/EN
7 Commissioning
7.4. End positions – Signaling gear
7
Commissioning
b) Set selection marker to 'Accept end
positions'menuitem(g.12,item4).
Continue with operation step 17.
■
Torque-dependent cut-off mode
Select operation CLOSE direction (OPEN
for setting in OPEN direction) and hold
down Drive Controller for more than 3 s.
The actuator automatically moves until
reaching the end position.
Display indicates whether the valid setting
range(g.12,item1)hasbeenreached
(3b) or not yet (3a) and the progress bar
(2) changes the color from yellow to green.
Once the tripping torque has been
reached, the "Tripping torque reached "
message (3b) is displayed and the "Accept
end position" menu item is active.(g.12,
item 4).
If "Torque dependent cut-off" is displayed
prior to reaching the valid setting range,
select "Help" and adjust the sliding wheel
in the signaling gear accordingly and
repeat end position adjustment (refer also
to step 7).
17. Conrm"Acceptendposition"
Thecorrectsettingisconrmedinthedis-
play(g.13).
18. Press Drive Controller. Actuator changes to
"End position" menu.
Now set the second end position of the me-
chanical position indicator, refer to chapter
„7.4.5 Adjust mechanical position indicator“
on page 55.
■
When changing to 'REMOTE' control, the actuator moves once an operation command from the
DCS is present!
■
Once the end positions have been adjusted during commissioning, the central wheel must not
be moved! Otherwise a complete readjustment of the end positions is required.
Fig� 12: Approach end position CLOSED
in torque dependent cut-off mode
Fig� 13: End position setting correct