11.15.1 MANAGEMENT OF AUTOMATIC LOADING AND UNLOADING SYSTEM - CB7015
The Smeg CB7015 product (“CB” stand for "Conveyor Belt”) is a system for the automatic loading and
unloading of washing trolleys in the chamber of Smeg WD7015 devices (washer-disinfectors for medical
use).
They subdivide into:
- Loading side systems, CB7015L (“L” for “Loading”)
- Unloading side systems, CB7015U (“U” for “Unloading”)
Please refer to the specific manual of the CB7015 product and the "Installation requirements” document
for operating details and technical characteristics.
The parameters of the WD7015 device must be suitably set, preferably in the factory, to control the
automatic system.
The superuser: can verify and modify the parameters associated to enabling of the system and automatic
operation of the device. The "Automatic operation" screen, already featured, has additional functions to
control the CB7015 system. These are only accessible to the superuser level (and above).
The tech user: can access the automatic operation diagnostic screens to monitor the input and output
signals for communication between the washer-disinfector and the external CB7015 devices.
In this documentation, and in the manuals supplied with the product, the CB7015 may also be referred to
as the "conveyor belt".
11.15.1.1 CB7015 AND AUTOMATIC OPERATION – ID.146B - 146C
This screen can be accessed by superuser level or above and allows activation of some device automatic
mechanisms associated to opening and closing of the doors. N.B.: the screen is only accessible for devices
with sliding doors.
To Next Page
