Smeg WD7010 - 11.5 MACHINE PARAMETERS - ID. 1.4.2.0

USER MANUAL
WD6010 – WD7010 – WD7015
Page 80 - 168
11.5 MACHINE PARAMETERS – ID. 1.4.2.0
Setup-> Machine parameters: Submenu of parameter setting accessible with password level “superuser” or
superior.
Menu entry
Access level
Chemical dosing
Superuser
Water
Technician
Program enable
Superuser
Optional
Technician
Password
Superuser
Restore values
Technician
Restore configuration
Technician
Calibrations
Technician
LAN parameters
Superuser
Full S/N, MAC, ID
Superuser
Heating type
(From CPU Firmware Main 6.2.0 and subsequent).
Superuser (To choose the washing chamber
heating type: Steam or electrical. This entry can
only be accessed if the optional Steam heating
system is installed on the machine).
Conductivity probe
Superuser (This entry can only be accessed if the
optional conductivity probe is installed)
Trolley check
Superuser (the option is only enabled if the
optional "RACKREC" Trolley Check system is
installed)
Spray arms check
Superuser (the option is only enabled if the
optional "ARMREC" Spray Arms Check system is
installed)
Automatic operation
Superuser (the option is only active for devices
with sliding doors).
The superuser can disable the Energy Management
interfacing function from this screen).
Barcode Scanner
Superuser (the option is only enabled if the
optional “WD-CODESCAN" barcode scanner is
installed).
Signal Box
Superuser (the option is only enabled if the “WD-
SIGNBOX15" optional component is installed).
Various active entries are detailed in the following sections.