2. Postponement: it is possible to set up a postponed cycle start, in case the unloading operations of
the machine must be synchronized with user availability.
3. Exclusion of purified water: by selecting this option, cold water will be used only during the
following cycle instead of purified water.
The option is activated by ticking the related box.
Selected option may be regulated through the +/-buttons, located on the right side.
The data is effectively changed by touching the CONFIRMATION button, located at the bottom right
corner of the screen.
10.4.4 CYCLE START – “USER CHECK” FUNCTION ACTIVE
If the superuser has activated the “User check” function requiring the user to be identified, in order to start the cycle
users must:
1. Be on the list of users enabled by the superuser.
2. Select their user ID (e.g. User_01) – using the “Right arrow" button.
3. Enter their passwords and confirm.
10.4.5 NOTES
Regarding thermal disinfection cycles versus chemical disinfection cycles, see suggestions from the product standard
ISO EN 15883.
Extracted from ISO EN 15883-1:
“4.1.5 Disinfection is specified by reference to time and temperature for thermal disinfection or as time,
Temperature and concentration for chemical disinfection.
Whenever practicable, thermal disinfection is preferred. Thermal disinfection processes are more easily
controlled and avoid the hazards to staff, patients and the environment that can occur through the use of
chemical disinfectants.”
Regarding significance of the Ao parameter, see Annex B, EN ISO 15883-1.
The parameter expresses “comparative lethality of moist heat processes”, and associates a numeric value with thermal
disinfection effectiveness. A0 concept — “Comparative lethality of moist heat processes”
To Next Page
Loading...
