11.5.1 DETERGENT DOSAGE SETUP (“Chemicals dosing”) – ID. 1.4.2.3
Password-level required: Superuser or superior level
From the “Setup” menu, please select “Device parameters” and then “Detergent dosage,” entering the password
when requested.
By selecting the preferred measuring pump, e.g. P1 for alkaline detergent, the amount of detergent used during the
wash phase can be regulated. The side buttons “Increase” e “Decrease” (+ / -) may be used to adjust the regulation.
Please note: Only by ticking the “Use as default values” box and selecting the check-box will the
values inserted be active for all washing programs. Otherwise, the values are saved but not active.
To Next Page
Loading...
