Warning: if possible, thermal disinfection is always more advisable than a chemical
disinfection process. According to regional regulations, the decontamination process with
chemical agents might be considered invalid by the responsible authorities, and can be used
only if the loaded items cannot bear the specific temperature of thermal disinfection.
The suggested washing and chemical disinfection cycles are specifically designed for the
recommended products and can be inappropriate with other chemical products. Do not use
products that were not specified by the manufacturer.
The authority responsible for the device and the decontamination process is also
responsible for the selection of the most appropriate treatment cycle.
CLOG WASHING AND DECONTAMINATION
The device where clogs are washed and decontaminated should be assigned to this specific
function, in order to avoid mistakes of use. Clogs require specific supports and specific cycles,
which are different from those used to process instruments.
6.2.1 AUTOMATIC LOADING AND UNLOADING SYSTEMS CB7015 SYSTEM SAFETY PRECAUTIONS
The CB7015 systems may only be disconnected from the device by one of the manufacturer's
authorised technicians, who must have read the CB7015 manual with care.
Devices prefitted for connection to CB7015 systems have connectors on their bottom plinth.
If the system is disconnected: the safety plug supplied must be used, as described below
Note for the technician: if the safety plug is not used or is not correctly connected, the device
may give the alarm that indicates that the emergency button has been pressed, since its
electrical connections are replicated on the external system of the CB7015. In this case, the
device is unusable.
DISCONNECTING CB7015 FROM THE DEVICE
The special “CB SAFETY PIN” (shown here) must always be used when disconnecting the system from
the device.
To Next Page
Loading...
