Smeg WD7010 - System Active - Power to Start Program Not Available

USER MANUAL
WD6010 – WD7010 – WD7015
Page 65 - 168
10.9.1 SYSTEM ACTIVE - POWER TO START PROGRAM NOT AVAILABLE
Description
Illustrations
Operation if power is not available
The system classifies emergency electricity supply
situations on the basis of thresholds.
If there is not enough power to start any one of the
cycles available on the device, a warning sign
(triangle and explanation mark) appears next to the
icon of the cycle concerned.
“Power not sufficient” icon: appears if the electrical
power available in the system is below the maximum
power required by the device.
It may be possible to start the device, for example for
low-power cycles.
The same icons appear in the cycle selected screen,
1110.
In this case, if the warning icon appears the cycle
cannot be started.
If only the “Energy Management” icon appears on
the top line, there is enough power to start the cycle.
With normal parameter settings, if there is not
enough power available the program cannot be
started.
If the system Consent Timeout parameter is set with
a value other than zero, even if the power is not
available the device may set in standby, ready to
start the cycle as soon as possible.
[Refer to the manual of the Energy Management,
“WD-EMS” product].
Alert screen 5000 requests confirmation to start the
timeout (“OK” button).
Otherwise, the start request can be cancelled (“ESC”
button).